: Users often find success by changing the Scan Level to "Clear + Factory scan" for stubborn drives, though "High scan" is the default for standard repairs.
This indicates a settings mismatch. Re-open the configuration panel, lower the clock frequency options (if available), or switch the scan mode to a deeper low-level analysis.
: Scans the NAND memory to identify and map out bad blocks, often reducing a fake high-capacity drive (e.g., 512GB) to its real size (e.g., 32GB or 64GB).
: Version V1.0.7.2 (2024-02-21) is the latest public build, offering a broader Flash database required for newer NAND types, such as some SanDisk dies. Typical Repair Workflow Firstchip Chipyc2019 Mp Tool
Click on the or Bin button (some versions require a blank password or "123456").
The unit feels utilitarian. The plastic shell is lightweight, and the PCB inside is bare-bones functional. The is Type-A or micro-USB depending on the revision; treat it gently, as the solder joints can be a weak point over time. The probe wires are thin but flexible. Pro tip: Add a dab of hot glue around the USB port for strain relief.
The "MP" in MP Tool stands for . USB flash drive manufacturers do not use standard Windows formatting tools to build flash drives. Instead, they use specialized production software provided by the controller manufacturer. : Users often find success by changing the
Verify the controller using ChipGenius. Switch to a rear motherboard USB 2.0 port.
: Forces a format on the NAND chip, often fixing "Write Protected" or "Read Only" errors. Capacity Restoration
controller. Look for the "Controller Part-Number" in the report. 2. Download and Launch the Tool Download the FirstChip FC1178/FC1179 MpTools from a reputable source like Unzip the archive and run the executable (typically FCMpTools.exe ) as an administrator. : Scans the NAND memory to identify and
Download a verified copy of the from a reputable firmware archive (such as USBDev or FlashBoot).
: If a 64GB drive only shows 16GB after repair, the drive was likely a "fake capacity" unit.
to begin the flashing process. This can take anywhere from a few minutes to over an hour depending on the drive's capacity (e.g., 16GB may take roughly 60 minutes). : This process will erase all data on the USB drive. 5. Verification
The USB drive is detected by Windows Device Manager but shows "0 Bytes" available in Disk Management.